Netgear Router Login |

Why does a Network Device Display

The IPv4 version of Internet Protocol consists of a contiguous range of IP addresses starting at and ending in Particularly important is the address which is not a general-purpose IP address. Whether you consider the IPv4 version of the Internet protocol or the IPv6 version, all zeros in the IP address have a specific purpose.

When do Network Clients Display the Address?

A device on a network shows the address in the following scenarios:

  • An IP address is not available for a device when it does not connect to the Local Area Network. Therefore, it displays as its address.
  • In another scenario, an offline device also assigns itself the address
  • Sometimes a DHCP server does not assign an IP address to a device, because of glitches during address assignment. The device will then display as its address and will not be able to communicate over a network.
  • In rare cases, the subnet mask and not the device IP address takes the value Modification of subnet mask is rare and has no practical significance in networking.

What is the Purpose of the IP Address?

Network Device Display

Sometimes, servers on a network might communicate over a network using multiple network interfaces. In multi-homed devices like these, the address is used by TCP/IP applications to monitor network traffic.

Another important scenario when the is visible is in the protocol header of certain messages with an unknown source.

The address is very different from the IP address On an IP network, servers a single purpose, by acting as the local loopback address. On the other hand, occurs in different networking situations with specific purposes.

Common Troubleshooting Scenarios with IP Address

  • Sometimes, even a device on a network which is configured properly for TCP/IP networking displays in place of its address. In this case, conventional troubleshooting by an administrator is required for a valid device IP address.
  • Most networks work with a dynamic IP address assignment scheme. In these cases, the most viable solution is to release and renew the IP address of that particular device.
  • Dynamic address assignment on a network happens through a DHCP server. When a problem of this sort continues to exist even after attempts to release and renew the IP address, the DHCP server might be the probable cause of the problem. Checking the DHCP server configuration helps resolve the issue.
  • When devices on a network rely on a static addressing scheme, a manual IP address configuration works best.

Leave a Reply